Description

Product name: HD rear arm (trailing arm)
For Suzuki Jimny JB64, Jimny Sierra JB74 Part
Material: Carbon steel pipe (STKN11S)
Paint color: Gun metallic paint
Installation: Genuine replacement (no installation instructions)
Vehicle inspection: Vehicle inspection compatible product (* 1)
Country of manufacture: Made in Japan

* Bush is not included in the product.

Jimny’s genuine leading arm and trailing arm are made of cast iron, which has a relatively low cost, so they may bend or break in the worst case if they are subjected to intense cross-country driving. If the arm breaks, not only will it not be able to move according to the road surface, but the coil spring will come off and the propeller shaft will come off, causing a risk of tipping over and a state of inability to drive.
The HD trailing arm body is made of sturdy drawn carbon steel pipe (STKM11S), and the sheer force is as high as about 20 times the axle load.

Both left and right have welded bosses for jacking up, similar to genuine arms. In addition, the rear arm is pre-embedded with a nut for fixing the brake hose, which is the same as the genuine one.

(* 1) Normally, no structural change is required and the vehicle inspection is compliant, so the strength calculation sheet is not attached to the product. There is a strength calculation sheet required when the structure is changed, so please let us know if you need it.

Leading arm & trailing arm rubber bush

Leading arm & trailing arm Rubber bush – 4,400 yen
For Suzuki Jimny
Applicable model: JA12,22, JB23,32,33,43
Jimny’s genuine bush may be torn due to particularly intense cross-country driving, or it may crack after many years of use and need to be replaced. However, it goes without saying that the bush itself is not sold and will be purchased as an arm assembly, which will be a very high expense. Jimny’s strong ally APIO has developed this bush so that you can enjoy the high driving performance as well as reduce the financial burden on the owner. In particular, a high-performance bush that uses a material with improved durability by changing the shape of the rubber part so that it can respond more flexibly to the violent movement of the arm during cross-country running.

This bush can be used on the front and rear hosing sides. A maximum of 8 units can be used. Since the size of the hole on the body side is different, it cannot be used, so please use the upper pillow bush or genuine bush.