Description

Product name: Tactical rear bumper
Compatible with: Suzuki Jimny Sierra JB74 only
*4-type back sonar vehicles require drilling

Unpainted Product No.: 3032-71
*Painted products will incur an additional painting fee of ¥33,000 (including tax)

Packing size: 1660mm x 280mm x 460mm (240 size)

*Unpainted products require processing to install corner flaps.
*Painted products have corner flaps already installed.
*This product is for Jimny Sierra JB74 only.
*The product shown in the image is painted.
*Design registered.

Material: ABS resin (vacuum forming)
Painting: Unpainted Installation
: Bolt-on installation
*The license plate needs to be moved to install.
Inspection: Inspection compliant
Accessories
Bumper body (ABS),
Wide extensions (left and right) (ABS),
Mounting bolts/stays,
Tail and stop lamp case,
Turn signal lamp case,
Back lamp case
reflector

ABS resin tactical rear bumper for the Sierra. The sharp and square design matches the Jimny Sierra JB74. The Jimny Sierra’s exclusive rear flap parts are included, and the design is both sharp and solid. A dedicated lamp case and reflector are also included.

A thin and sharp design is achieved by using a dedicated small lamp case.
The lamp bulb, socket, and harness are all genuine parts. Only the turn signal wiring needs to be extended.

The license plate will need to be moved due to the rear bumper replacement. Please use the license plate relocation kit for Jimny JB64/74 to relocate the license plate. *For Jimny Sierra, the license plate will need to be resealed.

[About installation]
The unpainted product with part number 3032-71 is an “unpainted, unprocessed product.”
It is necessary to drill holes in the bumper body to install the wide extension dedicated to JB74.
The surface condition of the bumper and wide extension parts requires painting; therefore, please paint them yourself before installation.
No drilling is required in the body for installation.

The painted product is “painted matte black, with holes drilled for wide extension installation.”
No drilling is required in the body for installation.

[About installing the rear sonar sensor on 4th generation and later models]
To embed the rear sonar sensor, you will need to drill a hole in the bumper. Please refer to the included instruction manual “Installation of the rear sonar sensor” for installation locations and installation methods. You can also check the instruction manual download at the bottom of this page.

License plate movement kit – 22,600 yen
For Suzuki Jimny JB64, Jimny Sierra JB74 Part
Material: Steel
Coating: Body / Black paint / Stay / Black cation
Installation: Bolt-on (Fixed with bolt and double-sided tape / Can be drilled and installed)
Vehicle inspection: Vehicle inspection compatible product
* When installing on the registered Jimny Sierra JB74, the number plate must be resealed.
* The nut on the back of the license plate is a drive-in type pop nut (a nut that cannot be turned), so in the case of Jimny Sierra, once the license plate is attached, the plate cannot be removed unless the seal is broken