JAOS BATTLEZ lift up set VFCA ver.B for Hilux 125
Product number: A733096B
Please select per-product shipping when placing the order. This can be shipped via economy air shipping to most parts of Asia, the US, and Europe. However, the territories cannot be covered
with this shipping, we may request an additional shipping charge after the buyer places the order.
4.5% deduction when paying via Bank/WISE Payment
|Product content||Front: Lift-up spring for vehicle height adjustment, damping force adjustable damper (with a wrench for vehicle height adjustment)
Rear: Lift-up block kit, damping force adjustable damper,
|Vehicle height||Lift up
front 20-50mm, rear 30mm
|Wire diameter||Front 17Φ|
|spring rate||Front: 120N/mm|
|type||Front: Low-pressure gas twin-tube damper, vehicle height adjustment, Harmoflex mechanism
Rear: Low-pressure gas twin-tube damper, Harmoflex mechanism
|Damping force adjustment||14 steps dial adjustment type|
|stroke||Front +12mm, Rear +33mm|
|body diameter||Front 54φ, Rear 54φ|
|piston diameter||Front 30φ, Rear 30φ|
|content||Leaf block: Aluminum, cationic electrodeposition coating, BATTLEZ logo stamped
long U-bolt: Steel, black coating Propeller shaft angle corrected, block rotation stop type
|Mounting method||genuine replacement + bolt-on|
|installation time||3.0 hours|
Installed between the rear leaf spring and hosing. U bolt genuine replacement
Safety equipment such as driver assistance systems and collision avoidance systems of each automobile manufacturer may cause radars, cameras, sensors, etc. to misrecognize or malfunction due to changes in vehicle height. Please note that we are not responsible for any malfunctions of these systems due to changes in vehicle height due to the installation of our lift-up (or low-down) suspension, or accidents caused by such malfunctions.
If the change in vehicle height is within 40mm, it is treated as a “minor change”, so no procedure is required for structural changes. However, if the total height of the vehicle changes by 40mm or more by installing it together with other products, it may be necessary to carry out a structural change procedure.
Due to the lift-up, there is a possibility that the front side visibility standard (Section 44, Paragraph 5 of the safety standards) may not be met, and it may be necessary to add a forward visibility confirmation mechanism such as a front view camera.
> Front view camera (reference): Our demo car uses the data system MVC811 multi-view camera
*The Z “GR SPORT” is equipped with a panoramic view monitor as standard, so there is no need to add it.
Due to individual differences in vehicles, it may not meet the standard (height 550mm) for the rush prevention device (rear bumper for Hilux). In that case, it is necessary to readjust the position of the rear bumper or reduce the height of the rear bumper to 550mm or less by using the “JAOS Rear Bumper Down Bracket (B318096).” In some cases, a structural change procedure may be required.
Although the Hilux is equipped with rear fog lamps as standard, the safety standards for rear fog lamps (rear fog lamps) (upper edge of 1 m or less from the ground: Article 37-2 of the safety standards) are stipulated by the lift-up on the rear side. may exceed it. However, since the back fog is not an essential lighting device for safety standards if you physically cancel (remove) it according to the procedure attached to the product, the non-conformance to safety standards will be resolved.
Can be installed after 20.08M/C (including Z “GR SPORT”)
H:525 × W:400 × D:210mm
H:225 × W:230 × D:770mm
Product weight (the weight of the product itself, excluding the package): 19.75 kg
Packing weight (packing weight): 22.4 kg
You may also like…
Toyota Hilux GUN125
125 Hilux Later Model (2020/08 ~)
WALD Black Bison Edition for Toyota Hilux HILUXGUN 125 2017.9 to 2020.7
There are no reviews yet.