Description

Sharp image rear bumper type 1 made of ABS.
Based on the one for JB64, widened for Sierra.
The thin design secures the departure angle. Not only does it make the rear area stylish, but it also allows for full-fledged off-road driving.
A genuine tail or LED tail for external JB64 can be installed.
In addition to making it a shape that fully covers the back part of the tail lamp, the wiring of the tail lamp is changed from the genuine top to the side to prevent the tail lamp from rainwater and mud from splashing from the tire.
This product is unpainted, so please paint it before using it.

Product comparison between ABS and FRP
・It is flexible and has elasticity even in situations where FRP would crack.
・It is possible to stably supply the same product with little individual product difference.
・Compared to FRP products, which can be mass-produced and tend to be out of stock, a stable supply is possible.
・Since the bumper surface is in good condition, less preparation is required during painting.

【Notes】
Installation requires moving the number and moving or removing the spare tire.
Compared to FRP products, there are fewer product errors, so there is basically no need to process the bumper body when installing, but it is not zero, so please adjust and process if necessary.
Items that have been installed cannot be returned.

If the installation of the tail lamp is tight, it may be necessary to make adjustments such as cutting the part that hits the tail lamp strongly.

Basically, the installation is a product that you ask a shop or maintenance company to install, so if you install it yourself, please understand the above contents and install it. If you have any questions about installation, please contact us.