Showa Garage ABS Rear Bumper Type II for Jimny JB74
¥65,000
Product No: E00660
Please select per-product shipping when placing the order. This can be shipped via economy air shipping to most parts of Asia, the US, and Europe. However, the territories cannot be covered with this shipping, we may request an additional shipping charge after the buyer places the order.
Description
【Description of item】
While maintaining the sharp style of the ABS rear bumper type 1, a new number pocket has been added.
The license plate fits neatly in the same center position as the genuine one, giving it a symmetrical and neat form.
The design that earns more angles than normal is not suitable for hard off-road driving, but the running performance is slightly improved.
Please use it for a casually eye-catching style that is a little different from the standard custom.
Although this model cannot avoid moving the spare tire, which is often required when replacing the short bumper, the license plate can be installed as before, so customization is possible at a low cost.
A genuine tail lamp or LED tail for JB64/74 outside the company can be installed.
The license plate light diverts genuine.
There is a hole for mounting the back camera.
A safe structure that fully covers the back of the tail lamp and protects it from rainwater and mud splashing.
This product is unpainted, so please paint it before using it.
Product comparison between ABS and FRP
・It is flexible and has elasticity even in situations where FRP would crack.
・It is possible to stably supply the same product with little individual product difference.
・Compared to FRP products, which can be mass-produced and tend to be out of stock, a stable supply is possible.
・Because the bumper surface is in good condition, it is possible to supply the bumper with a good paint finish in a stable condition.
【Notes】
The spare tire must be moved or removed.
When installing, it is necessary to reseal the license plate because it is necessary to attach and detach it.
Since there are fewer product errors than FRP products, there is basically no processing of the bumper body when installing, but please adjust and process if necessary.
If the installation of the tail lamp is tight, it may be necessary to make adjustments such as cutting the part that hits the tail lamp strongly.
Installation of the back camera requires processing.
Basically, the installation is a product that you ask a shop or maintenance company to install, so if you install it yourself, please understand the above contents and install it.
You must be logged in to post a review.
You may also like…
-
Jimny JB74
-
Jimny JB64/ Siera JB74
-
JIMNY JB64W/JB74W
Reviews
There are no reviews yet.