Description

20mm wide over the fender on one side for the standard bumper.
Size setting that best matches the standard 2-inch lift specification for customizing the 150 Prado.
Although the width is modest, setting the height and line position creates a sense of volume.
The apex is approximately 20mm wide at both the front and rear and becomes thinner towards the ends.
The silhouette is adjusted when viewed from the front and back.
It also features a side rivet style design to emphasize the off-road taste.
*Dummy rivets are sold separately (18,000 yen for 40 pieces)

All pieces have a surface for pasting double-sided tape on the back to ensure a secure fit.

-Material: FRP black gel coat finish (unpainted product)
*A separate painting is required for installation.
*We do not accept orders for painted products.

●Wide amount: Front side approx. 20mm, rear side approx. 20mm
●Product composition: Front 4 pieces, rear four pieces, double-sided tape, rubber edges, etc. Complete set of screws required for installation
●Installation information: September 2017 model – for standard bumper vehicles
*Drilling on the vehicle side is required for installation.

●Package size: 107cm x 81cm x 30cm
●Packaging weight: 7.8kg
●Product weight: 5.4kg

◆Fender edge rubber color selection
●Black
●Gray

[MADE IN JAPAN]