Description

Applying a rubber coating to the low-vibration special plate, suppresses the vibration between the caliper and the brake pad when the brake is applied, preventing brake squeal.

Application: Suppression of noise caused by brakes

Applying a rubber coating to the low-vibration special plate, suppresses the vibration between the caliper and the brake pad when the brake is applied, preventing brake squeal.
【installation method】
Clean and degrease the back plate surface of the brake pad before attaching it to the back plate.
Make sure the anti-noise shims do not protrude beyond the backplate.

【Note】
・Since the anti-noise shim is bonded with tape, it may slip off from the brake pad at high temperatures. Please remove this anti-noise shim when using this product when the brakes become hot, such as when driving on a circuit.
・Cannot be used in environments where the brakes become hot, such as when driving on winding roads or circuits.
・When anti-noise shims are installed, the pedal touch becomes softer. We recommend that you do not use this product if you value pedal touch and brake feel.
– If either the brake pad or brake rotor is installed when either the brake pad or the brake rotor is worn out, squealing is likely to occur.
・Anti-noise shim is a product to reduce brake squeal. It does not mean that the noise will not occur at all by wearing it.
・The brake system is an important safety component. Please perform disassembly and maintenance at a certified factory or maintenance factory.
・This product is not a product that reduces friction noise generated between brake pads and rotors.

*If you install the anti-noise shim, the pedal touch will be softer. We do not recommend using this product if you value brake feel. (Squealing is more likely to occur.)
* If either the brake pad or the brake rotor is worn, it will cause squealing.
*This product is not a product that reduces frictional noise generated between brake pads and rotors.
*Anti-noise shim is a product that reduces brake squeal. Installing the product does not mean that the noise will not occur at all.
*The brake system is an important safety component. Please perform disassembly and maintenance at a certified factory or maintenance factory.
*Be sure to remove the anti-noise shim when using it on a circuit or under high load.
*Anti-noise shims that are attached to tape will lose their adhesive strength over time. Periodically check that the brake pads have not shifted or fallen off.