Goonies One GB Design Three Feet Roof Rack for JIMNY JB64/JB74
Original price was: ¥98,000.¥92,000Current price is: ¥92,000.
Part number: OGB-64-0017

Please select per-product shipping when placing the order. This can be shipped via economy air shipping to most parts of Asia, the US, and Europe. However, the territories cannot be covered with this shipping, we may request an additional shipping charge after the buyer places the order.
Description
New Jimny Exclusive GB Roof Basket
This is a roof rack that can be installed on the new JB64 Jimny and JB74 Jimny Sierra. We have also paid attention to the design so that it matches the exterior image of the Jimny. This product has been improved from the conventional 2-foot type on one side to a 3-foot type to increase stability and load capacity for owners who carry heavy loads. The conventional 2-foot type still has a general load capacity. Please choose according to the owner’s purpose. This is a roof rack set that can be installed without a base carrier. The total weight is 20 kg, the roof rack part is made of aluminum, and the foot part is made of steel to increase strength. The paint is a black powder coat finish after cathodic electrocoating. The bolts and feet are also treated with anti-rust treatment, so they are less likely to rust. The size is length 1540 mm, width 1260 mm, height 190 mm (up to the lower rack) 270 mm (up to the upper rack). It is designed to suppress wind noise and resonance noise when driving. A set of 8 round hook plates that can be conveniently attached to the surface of the roof rack. Maximum load capacity: 50kg
Total weight: 20kg
Material: Main body: Aluminum extrusion
Corner parts: PA6+GF (reinforced plastic)
Reinforcement and foot parts: Iron (powder coated)
Accessories: Towing eye plates (iron) x 8 included
Painting: Cationic electrocoating, black powder coat finish
Size: Length 1540mm, width 1260mm, height 270mm
Planning: Japan
Manufactured: China
*Please be careful not to concentrate the weight on one point or place items with a high center of gravity on it.
*The foot holder comes into direct contact with the vehicle, so it may get scratched. Please attach the enclosed protective sticker to the foot.
*Assembly of the product is required for installation. Assembly instructions are included.
Assembly takes 1 to 1.5 hours, and we recommend that two people work together to install the product on the vehicle.
In order to ensure that you can purchase with confidence, we open all products before shipping and check the condition of the product and the paint for any defects (including mounting bolts and metal fittings) before shipping. Please note that since this is an overseas product, there may be some scratches, dirt, uneven paint, etc. If you lose or damage any products such as bolts during assembly, please contact us and we will assist you.
You must be logged in to post a review.
You may also like…
-
OGB Rear Multi Step S Size for JIMNY
Original price was: ¥54,000.¥49,000Current price is: ¥49,000.Compatible with JB64,JB74 -
APIO MCB Motion Control Beam Kit Jimny JB64/JB74
Original price was: ¥160,000.¥155,000Current price is: ¥155,000.JB64/JB74 -
OGB Rear Multi Step Holders for JIMNY
Original price was: ¥5,200.¥4,961Current price is: ¥4,961.Compatible with JB64,JB74




















Reviews
There are no reviews yet.