RIGID Clutch Stopper for Toyota 86/GR86/BRZ/WRX

Part number:AA1014
If installing on both the push side and the return side, please purchase two

This can be shipped via economy air shipping to most parts of Asia, the US, and Europe. However, the territories cannot be covered with this shipping, we may request an additional shipping charge after the buyer places the order.

Description

The installation method is to replace the original stopper, so the clip can be easily attached without drilling holes.
By replacing the two stoppers on the push side and return side,
you can improve your driving position and make the clutch work faster.

“Bush side”
The clutch push position moves about 10mm forward.
(When installed, the clutch switch may not be pushed all the way and the starter motor may not turn, so if a malfunction occurs, the switch part will need to be adjusted.)

Push side – genuine stopper

Push side – AA1014 installed

“Return side”
The height of the clutch pedal will be lowered by approximately 10 mm.
(When installed, the bush rod may lose play, so please adjust the rod if this occurs.)

Return side: OEM stopper.

Return side: AA1014 installed.

Material: Duracon.
Compatible models:
Toyota: B6 (ZN6)
(Compatible with vehicles equipped with OEM part number: SU003-00975.)
Subaru: BRZ (ZC6, ZD8)
Subaru: Impreza, WRX (GC8, GDB, GDA, GRB, GVB, VAB)
(Compatible with vehicles equipped with OEM part number: 36036-AA080.)

Part number: AA1014
* (If installing on both the push side and the return side, please purchase two.)