Description

Product Name: JB74 ABS narrow fender
Compatible with: Jimny Sierra JB74
(for vehicles equipped with APIO tactical bumpers)

Model: 3032-20
Material: ABS resin (vacuum molding)
Mounting: Bolt-on mounting
Set contents: Fender and dummy bolt head (30 pieces) for the front, rear, left, and right
Car inspection: Car inspection compatible product (change required)

Packing size: 1,115mm x 520mm x 340mm (200 size)
Packing weight: Approximately 5kg

Narrow over fender for Jimny Sierra JB74 made of ABS resin.
It will be an unpainted product, but it is a quality that can be used as it is.
* If gasoline drips, the color may change (it may lose its luster), so wipe it off quickly.

The model was changed from the previous model, JB43, to Jimny Sierra JB74, and the larger over-fenders are a powerful and popular point. However, when actually using the JB74, there is also a situation
where the narrow forest road in Japan is too broad to proceed … So at Apio, while leaving the room for the Jimny Sierra JB74, which has evolved into a 1.5L engine, I dare to do it. I made a narrow fender that suppresses the overfender by about 30 mm on each side.

Fender size comparison

Genuine fender width
F: 90mm on one side
R: 85mm on one side

Apio narrow fender width
F: 61mm on one side
R: 58mm on one side

Apio’s “JB74 Narrow Sierra” has a narrower vehicle width than its predecessor, making it possible to drive lightly on Japanese and forest roads without worrying about the width. By replacing the standard fender with a “narrow fender”, the front is narrowed by 58mm (29mm on one side) and the rear is narrowed by 54mm (27mm on one side).
The wheels have been changed from 15 to 16 inches, and tires with a narrow width and height have been set. This has also succeeded in increasing the ground clearance.

Parts required for mounting

1. JB64 tactical rear bumper and number transfer kit
It is necessary to install the JB64 rear tactical bumper (part number: 3032-70 / 3032-70B). The rear terminal has a shape that matches the rear tactical bumper side for JB64. In addition, a number transfer kit (part number: 3060-25) is required when installing the tactical rear bumper.

2. Side sill guard
It will be installed by removing the genuine side skirt. Since the clip hole of the genuine side skirt remains on the body side where it was removed, it is recommended to install the HD side sill guard (part number: 3102-69).

3. Size wheel for JB64
If it is a genuine Sierra offset wheel, it will come out from the fender, so it is recommended that a wheel be installed for the light car, Jimny. At Apio, we have chosen the WIDBOAR series 16-inch 5.5J inset 20 with 6.50R16 tires and 205R16 tires for the wheels equipped with the 40mm up suspension kit. (* The photo is 205R16)