Description

Meteor version with flowing turn signals
The turn signals, which are blinking on the factory version, are now sequential.
High-brightness LEDs provide good visibility.

Built-in L-shaped light bar with opening function and W function
The L-shaped light bar is equipped with two levels of light, which is ideal for linking the small lamps and brake lamps.
The small lamps are equipped with an opening function (ON/OFF possible),
creating a powerful rear view.

■How to switch opening actions

〇Opening OFF
①Start the engine
②While stepping on the brake lamp, turn the small lamp ON/OFF three times
③Wait 5 seconds and release the brake

●Opening ON
①Start the engine
②While stepping on the brake lamp, turn the small lamp ON/OFF four times
③Wait 5 seconds and release the brake

※You cannot switch when the auto light is operating (lights are on) at night or in a dark environment.
When switching at night, etc., please use a light or other object to illuminate the sunlight sensor located at the top of the dashboard to simulate an auto light-off environment and make the change.

Built-in LED back lamp
Built-in back lamp using three high-brightness LEDs.
Crystal cut lens is used, giving it a stylish finish even when turned off.
Built-in LED reflector with reflective function
Built-in reflector with reflective function for safety.
LED is built inside, and it is equipped with functions that can be used at will, such as linking to the rear fog lights on vehicles equipped with rear fog lights, and linking to the brakes on vehicles not equipped with rear fog lights.

Genuine replacement / coupler-on design
The turn signals and back lamps can be connected with a coupler-on without any wiring processing.
Other functions can be used by wiring as you like.

* Wiring work is required regardless of whether the rear fog lamp is standard equipment or not.
Can also be linked with tail lamps
Wiring specification that allows linking with tail lamps handled by our company by coupler-on.
Opening function and sequential function can be used in sync.

Wiring specifications
– Turn signals: Coupler on/branch socket is for extracting power when tail lamps are installed at the same time
– Reverse lamps: Coupler on
– L-shaped light bar: Coupler on when tail lamps are installed at the same time (use included extension harness)
* If installing only the bumper light, cut the socket and connect the green to the small lights and the red to the brake.
– Rear fog (brake) lamps: If the vehicle is equipped with rear fog lights, connect to the rear fog light wiring.

If the vehicle is not equipped with rear fog lights, connect to the brake lights, etc.