FrogDrive Steering switch case for GR Corolla
Original price was: ¥88,000.¥85,000Current price is: ¥85,000.
Please select per-product shipping when placing the order. This can be shipped via economy air shipping to most parts of Asia, the US, and Europe. However, the territories cannot be covered
with this shipping, we may request an additional shipping charge after the buyer places the order.
Description
This is a case kit that allows you to directly transfer the function switch on the genuine steering wheel to the switch case when replaced with an aftermarket steering wheel.
We developed the product for the GR Corolla based on our past design knowledge of other car models.
The switch layout has been optimized by using rocker paddle-type switches for some of the switches.
This makes it possible to support many types of steering.
【material】
Surface: Dry carbon Back side: ABS
[Confirmed compatibility handle]
-Confirmed as of December 1, 2022.
momo JET 32
momo M08
OMP WRC
OMP Targa 33
OMP VOLANTE 320※
*A 5mm spacer is required separately.
[Note] A separate steering boss is required for installation.
[About Boss and Rafix 2]
The steering switch case (hereinafter referred to as SSC) is compatible with Works Bell Boss and Rafix 2.
The order in which they can be installed is as follows.
■Installation order
pattern 1
Vehicle body → Boss → SSC → SW
pattern 2
Vehicle body → Short boss → RAPFIXⅡ → SSC → SW
pattern 3
Vehicle body → Short boss → SSC → RAPFIXⅡ → SW
*SSC (steering switch case)
*SW (steering wheel)
*For pattern 2, a 13-pole insulator flipper is required.
[About the 13-pole insulator]
When fixing with Rafix 2, install this product between the steering wheel and Rafix (Pattern 2 above)
In that case, you will need a pre-wired 13-pole insulator.
Works Bell’s 13-pole insulator is not wired. Our store sells pre-wired 13-pole insulators, so please feel free to contact us.
[About CVT vehicles]
If you have a CVT vehicle, replacing the steering wheel will disable the paddle shift.
Please purchase our original paddle unit separately.
[About GTC]
When installing with Works Bell’s RAPFIX GTC, it cannot be installed unless the SSC and roll connector connection is passed through the outside of the product.
If you select GTC when ordering, additional parts will be added.
Dedicated cord (extension cord)・・・¥4,000
15mm spacer・・・¥2,000
[About installation]
Installation can also be done at our store.
In that case, you will need to purchase Rafix-related items (Rafix, vehicle-specific short boss, flipper, 13-pole insulator) or steering boss from our store, or bring them in.
If you would like to install it at our store, please select and purchase a processed 13-pole insulator.
You must be logged in to post a review.
You may also like…
-
Works Bell Universal Hub kit Standard Boss #550
Original price was: ¥27,000.¥20,000Current price is: ¥20,000.Toyota -
FJCRAFT Standard Pattern Floor Mat & Luggage Mat for GR Corolla
Original price was: ¥30,000.¥27,000Current price is: ¥27,000.Check Rubber Waterproof Made in Japan -
CUSCO REINFORCED TRANSMISSION CLUTCH HUB FULL SET – GR COROLLA/GR YARIS
Original price was: ¥1,980,000.¥170,000Current price is: ¥170,000.GR COROLLA GZEA14H GR YARIS GXPA16
Reviews
There are no reviews yet.