Description

Description of item
This sale is for the rear bumper only. Please prepare the tail lamp separately.
By using the tail lamp for the Alto tail (for HA36), the bumper can be made thin and stylish. Unpainted ABS model.
ABS resin is used as the raw material for a finish with few errors. Reduced the time and effort of matching the actual product that accompanies FRP.
The back side of the bumper has a full cover shape, which protects the tail lamps from rainwater and mud rolled up by the tires.
Alto HA36 genuine tail lamp cannot be installed. HA36 made by M Bro or 415COBRA can be installed (conformity of tail lamps of other manufacturers has not been confirmed).
Defects due to installation of tail lamps other than conformity confirmed tail lamps are not covered by warranty such as returns and exchanges including support.

Product comparison between ABS and FRP
・It is flexible and has elasticity even in situations where FRP would crack.
・It is possible to stably supply the same product with little individual product difference.
・Compared to FRP products, which can be mass-produced and tend to be out of stock, a stable supply is possible.
・Because the bumper surface is in good condition, it is possible to supply the bumper with a good paint finish in a stable condition.

【Notes】
Installation requires moving the number and moving or removing the spare tire.
Since there are a few individual differences that occur during the production of ABS products, there is basically no processing at the time of installation, but in rare cases, it may be necessary.
Please be sure to use it after painting.